
Product code: 32004.165.92.CZ
€386.74
Buying for a business or in larger quantities? Request a B2B quote
The straight edge of the panel sits flush with the corner's arris, and the hand reaches around the corner onto the adjacent wall — the figure looks as if it is hiding behind the house and peeking out. The effect reads within a range of 30–150° relative to the wall with the panel; beyond that angle you only see the sheet metal from the side. From 15 m away, the 165 cm silhouette looks like a figure standing behind the building.
This silhouette only works on an outside corner on the left side and will not work on a flat wall or an inside corner. Measure before ordering: 112 cm of clear wall to the side of the corner, 195 cm up from the ground, and the corner's plumb deviation under 5 mm along the full height of the panel.
A ghost with one oval eye and an open mouth, the lower edge flowing out in six waves, one arm stretched out and wrapping around the corner.
One piece cut from 3 mm sheet steel — no welds, bends or added parts. Every detail is a through-cut opening, and the open area makes up 28% of the silhouette's surface. Not a single screw, mounting hole or bracket is visible from the front: the panel hangs on spacers hidden behind it and casts its own shadow on the plaster.
Product details
| Parameter | Value | What it means |
|---|---|---|
| Dimensions | 92 × 165 cm | requires a clear stretch of wall 112 cm wide and 195 cm high |
| Weight | 25,8 kg | for designs over 150 cm, installation takes two people |
| Material surface area | 1,09 m² | in a 100 km/h wind, a force equivalent to about 53 kg |
| Openness | 28% of the silhouette's surface | that much of the plaster shows through the cut-outs |
| Corner side | left | the straight edge of the panel sits flush with the corner on this side |
| Sheet thickness | 3 mm | the panel does not flutter in the wind and needs no frame |
The fixing must pass through the insulation and anchor into the load-bearing layer — a plug set in polystyrene alone will not hold 25.8 kg. The first installation takes about 60 minutes, and each following season just a few minutes, because the anchors stay in the wall. Every hole in the facade layer must be sealed: an unsealed hole lets water in under the plaster, and at the first frost the freezing water lifts the plaster off around the hole.
Matte black is the finish the effect is built on — a dark silhouette on light plaster reads as a shadow. Corten gives a rusty figure that looks like a sculpture, but for the first 6–12 months it stains the plaster beneath the panel, so on a light facade choose black.
The powder coating does not wear off from water or frost; Corten has no coating, because the patina itself stops corrosion beneath it. After the season, the panel comes off the anchors and can be stored flat — it is only 3 mm thick. The manufacturer is Metal4Home, a brand of Adjatech Metalworking Sp. z o.o., a maker of metal decorations from Poznań.
Questions and answers
Only on an outside corner and only on the left side — the straight edge of the plate has to sit flush with the edge of the corner, and a 2 cm strip of plaster between them is enough to ruin the effect. You need a clear stretch of wall 112 cm sideways from the corner and 195 cm up from the ground.
Not on the insulation alone — an anchor set in 12–20 cm of polystyrene won't hold a 25.8 kg plate. The fixing has to pass through the insulation and anchor into the load-bearing layer beneath the plaster. You can check the insulation thickness with a test drill hole under the windowsill.
In a 100 km/h wind, a force of about 53 kg acts on a material surface of 1.09 m², which is more than the plate's own weight. That's why the number and type of fixings is a structural decision here, not a matter of convenience.
Matte black on a light facade — the dark silhouette reads as a shadow, and from 15 m you cannot tell it is sheet metal. Corten gives a rusty figure that looks like a sculpture, but for the first 6–12 months the patina runs off with the rain and stains the plaster beneath the panel. On white and cream plaster, choose black.
| Finishes: | Corten, Black |
|---|---|
| Dimensions: | 92×165 cm |
| Finish and color | |
| Size | |
| Mounting and display | Outdoor (weather-resistant) |
| Themes | |
| Room | Garden, Facade and entrance |
We use cookies to make it easier for you to navigate and to enable certain features. You will find detailed information about all cookies below under each consent category.
Cookies classified as "necessary" are stored in your browser because they are essential for enabling the basic functionality of the website.
We also use third-party cookies that help us analyze how you use this website, store your preferences, and deliver content and ads that are relevant to you. These cookies will be stored in your browser only with your prior consent.
You can enable or disable some or all of these cookies, but disabling some of them may affect your browsing experience.
